6 questions
Looking at the SPRESENSE specification, it is divided into three parts: CXD5602 pin nameArdirno pin nameFunctoin pin nameI need two UARTs and six GPIOs for an external connection, and one of the UARTs...
Looking at the SPRESENSE specification, it is divided into three parts: CXD5602 pin nameArdirno pin nameFunctoin pin nameI need two UARTs and six GPIOs for an external connection, and one of the UARTs...
I would like to measure Co2 concentration using Raspberry Pi3.I am connecting to the following site for reference.None appears when the program is running and cannot be measured.I'm at a loss because ...
I used RaspberryPi3B+ as an infrared remote control and used it for lighting.At one point, the update failed and 3B+ stopped booting, so I re-entered the operating system.Then, I couldn't operate with...
I'm trying to control GPIO with SPRESENSE SDK.Include the following I tried to use board_gpio_config or board_gpio_write, but I got an error message and couldn't use it.Do I need any special settings ...
I'm a beginner at Raspberry.The CO2 sensor MH-Z19 and Razpie 3 model B are trying to be male-mixed.However, if you connect the 6th GND of the Raspie GPIO to the sensor side GND (number 7), the Raspie ...
© 2024 OneMinuteCode. All rights reserved.